Crankshaft Pulley: Installation

WARNING: This page is about a different variant/trim than selected.

1.

Lubricate with clean engine oil.

GFD34573

Courtesy of FORD MOTOR COMPANY

2.

Special Tool(s): Installer, Front Cover Oil Seal 303-335 and Replacer, Crankshaft Vibration Damper 303-102 (T74P-6316-B). Install the crankshaft pulley.

GFD34574

Courtesy of FORD MOTOR COMPANY

3.

Install the crankshaft pulley washer and new bolt and tighten in 4 stages.
- Stage 1: Tighten to 120 Nm (89 lb-ft).
- Stage 2: Loosen one full turn.
- Stage 3: Tighten to 50 Nm (37 lb-ft).
- Stage 4: Tighten an additional 90 degrees.

GFD34860

Courtesy of FORD MOTOR COMPANY

4.

Install the accessory drive belt. REFER to Accessory Drive .

5.

Install the underbody air duct and the 3 twist lock retainers.

GFD34445

Courtesy of FORD MOTOR COMPANY

6.

Install the RH splash shield. REFER to Front End Body Panels .

7.

After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.