Removal And Installation

WARNING: This page is about a different variant/trim than selected.

1.

Drain the cooling system. REFER to Engine Cooling .

2.

Remove the 3 twist lock retainers and the underbody air duct.

GFD34445

Courtesy of FORD MOTOR COMPANY

NOTE: Failure to position the wood block and floor jack as illustrated can result in damage to the oil pan.

3.
Position a floor jack with a block of wood under the front of the oil pan.

GFD34654

Courtesy of FORD MOTOR COMPANY

4.

Remove the engine coolant degas bottle. REFER to Engine Cooling .

5.

Disconnect the upper radiator hose from the intake manifold.

GFD34898

Courtesy of FORD MOTOR COMPANY

6.

Remove the A/C tube bracket bolts from the upper and lower RH shock tower.
1. 1.
  
  To install, tighten to 15 Nm (133 lb-in).
1. 2.
  
  To install, tighten to 9 Nm (80 lb-in).

GFD34899

Courtesy of FORD MOTOR COMPANY

7.

Remove the 4 nuts, 3 bolts and the engine mount.
- To install, tighten the bolts to 90 Nm (66 lb-ft).
- To install, tighten the nuts to 63 Nm (46 lb-ft).

GFD34900

Courtesy of FORD MOTOR COMPANY

8.

To install, reverse the removal procedure.

9.

Fill and bleed the cooling system. REFER to Engine Cooling .