Removal And Installation
WARNING: This page is about a different variant/trim than selected.
- 1.
With the vehicle in NEUTRAL, position it on a hoist. REFER to Jacking and Lifting
.
- 2.
Disconnect the Engine Oil Pressure (EOP) switch electrical connector.
 Courtesy of FORD MOTOR COMPANY
|
- 3.
Remove the EOP switch.
- To install, tighten to 14 Nm (124 lb-in) plus an additional 180 degrees.
 Courtesy of FORD MOTOR COMPANY
|
- 4.
To install, reverse the removal procedure.
- Apply thread sealant with PTFE to the EOP switch threads prior to installation.