Compressor to Condenser Discharge Line - 3.5L Ti-VCT: Installation

1. 1.
   
   Install the compressor-to-condenser discharge line.

1. 2.
   
   Using a new O-ring seal, connect the condenser inlet fitting and install the nut.
   • Tighten to 20 Nm (177 lb-in).

1. 3.
   
   Connect the A/C pressure transducer electrical connector.

1. 4.
   
   Using a new O-ring seal, connect the A/C compressor discharge fitting and install the nut.
   • Tighten to 20 Nm (177 lb-in).

1. 5.
   
   Install the rear A/C compressor bolt.
   • Tighten to 25 Nm (18 lb-ft).

1. 6.
   
   Install the underbody air duct and the 3 twist lock retainers.

Courtesy of FORD MOTOR COMPANY

1. 7.
   
   Recharge the A/C system. Refer to Air Conditioning (A/C) System Recovery, Evacuation and Charging .