Side Impact Sensor - C-Pillar: Installation

1.

NOTE: Make sure the C-pillar and side impact sensor mating surfaces are clean and free of foreign material.

Position the side impact sensor, install the side impact sensor bolt and connect the side impact sensor electrical connector.
- Tighten to 12 Nm (106 lb-in).

2.

NOTE: To avoid damage to the quarter trim panels, remove any retaining clips from the body and attach them to the quarter trim panels before installing.

Install the quarter trim panel at the front.

3.

NOTE: To avoid damage to the rear door scuff plate trim panel, remove any retaining clips from the body and attach them to the rear door scuff plate trim panel before installing.

Install the rear door scuff plate trim panel.

4.

Attach the load floor flapper panel(s) to the load floor support(s).

5.

If necessary, reposition the second and third row seats.

6.

Repower the SRS. Refer to Supplemental Restraint System (SRS) Depowering and Repowering - With Intelligent Access (IA) or Supplemental Restraint System (SRS) Depowering and Repowering - Without Intelligent Access (IA) .