LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2015 >> Explorer Limited, 3.5L Eng VIN 8, AWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seating System - 1ST Row >> Diagnosis And Testing >> Seating >> Pinpoint Tests >> Pinpoint Test S : B1113, B111B >> Pinpoint Test S : B1113, B111B

Pinpoint Test S : B1113, B111B

NOTE: When taking measurements at DCSM harness connectors, do not insert the electrical probes into the female connector pins. Inserting the probes into connector pins can cause intermittent or open electrical connections after reassembly resulting in DTCs and system failure. Touching the tip of these connector pins is recommended instead.

  1. S1 CHECK THE TED CIRCUITS FOR A SHORT TO GROUND

      WARNING: Turn the ignition OFF and wait one minute to deplete the backup power supply. Failure to follow this instruction may result in serious personal injury or death in the event of an accidental deployment.

    • Ignition OFF.

    • Disconnect: Passenger Seat Side Air Bag C339 .
    • Measure:
      Positive Lead Measurement / Action Negative Lead
      C3265A-A
      GFD33596Courtesy of FORD MOTOR COMPANY
      		 Ground
      C3265A-B
      GFD33596Courtesy of FORD MOTOR COMPANY
      		 Ground
      C3265A-C
      GFD33596Courtesy of FORD MOTOR COMPANY
      		 Ground
      C3265A-D
      GFD33596Courtesy of FORD MOTOR COMPANY
      		 Ground

    Are the resistances greater than 10, 000 ohms? 

    Yes  GO to  S2.
    No  If the resistances of C3265A-A and/or C3265A-B to ground were not greater than 10, 000 ohms to ground, GO to  S6. If resistances of C3265A-C and/or C3265A-D to ground were not greater than 10, 000 ohms to ground, GO to  S7.

  2. S2 CHECK THE TED CIRCUITS FOR A SHORT TO VOLTAGE

    • Ignition ON.
    • Measure:
      Positive Lead Measurement / Action Negative Lead
      C3265A-A
      GFD33595Courtesy of FORD MOTOR COMPANY
      		 Ground
      C3265A-B
      GFD33595Courtesy of FORD MOTOR COMPANY
      		 Ground
      C3265A-C
      GFD33595Courtesy of FORD MOTOR COMPANY
      		 Ground
      C3265A-D
      GFD33595Courtesy of FORD MOTOR COMPANY
      		 Ground

    Is any voltage present? 

    Yes  If voltage is present at C3265A-A and/or C3265A-B , GO to  S8. If voltage is present at C3265A-C and/or C3265A-D , GO to  S9.
    No  GO to  S3.

  3. S3 CHECK THE TED RESISTANCE

    • Ignition OFF.
      NOTE: Make sure the TEDs are at room temperature and there is no air blowing across the TEDs. Do not handle a TED when measuring resistance. These conditions can cause incorrect readings and lead to incorrect identification of components that are not damaged.
    • Measure:
      Positive Lead Measurement / Action Negative Lead
      C3265A-A
      GFD33596Courtesy of FORD MOTOR COMPANY
      		 C3265A-B
      C3265A-C
      GFD33596Courtesy of FORD MOTOR COMPANY
      		 C3265A-D

    Are the resistances between 0.9 and 10 ohms? 

    Yes  GO to  S10.
    No  If the resistance between DCSM C3265A-A and C3265A-B was not between 0.9 and 10 ohms, GO to  S5. If the resistance between DCSM C3265A-C and C3265A-D was not between 0.9 and 10 ohms, GO to  S4.

  4. S4 CHECK THE RESISTANCE OF THE BACKREST TED

    • Disconnect: Passenger Backrest TED C3039 .
    • Measure the component side  resistance:
      Positive Lead Measurement / Action Negative Lead
      Passenger Seat Backrest TED C3039-1, Component Side
      GFD33596Courtesy of FORD MOTOR COMPANY
      		 Passenger Seat Backrest TED C3039-3, Component Side

    Is the resistance between 0.9 and 10 ohms? 

    Yes  REPAIR circuit CHS01 (GY/VT) or RHS01 (WH/VT) for an open circuit or high resistance. GO to  S11.
    No  INSTALL a new seat backrest TED. Refer to Seat Backrest Thermo-Electric Device (TED) . GO to  S11.

  5. S5 CHECK THE RESISTANCE OF THE CUSHION TED

    • Disconnect: Passenger Cushion TED C3040 .
    • Measure the component side  resistance:
      Positive Lead Measurement / Action Negative Lead
      Passenger Seat Cushion TED C3040-1, Component Side
      GFD33596Courtesy of FORD MOTOR COMPANY
      		 Passenger Seat Cushion TED C3040-3, Component Side

    Is the resistance between 0.9 and 10 ohms? 

    Yes  REPAIR circuit CHS01 (GY/VT) or RHS01 (WH/VT) for an open circuit or high resistance. GO to  S11.
    No  INSTALL a new seat cushion TED. Refer to Seat Cushion Thermo-Electric Device (TED) . GO to  S11.

  6. S6 CHECK THE CUSHION TED CIRCUITS FOR A SHORT TO GROUND

    • Disconnect: Passenger Cushion TED C3040 .
    • Measure:
      Positive Lead Measurement / Action Negative Lead
      C3265A-A
      GFD33596Courtesy of FORD MOTOR COMPANY
      		 Ground
      C3265A-B
      GFD33596Courtesy of FORD MOTOR COMPANY
      		 Ground

    Are the resistances greater than 10, 000 ohms? 

    Yes  INSTALL a new seat cushion TED. Refer to Seat Cushion Thermo-Electric Device (TED) . GO to  S11.
    No  REPAIR the affected circuit. GO to  S11.

  7. S7 CHECK THE BACKREST TED CIRCUITS FOR A SHORT TO GROUND

    • Disconnect: Passenger Backrest TED C3039 .
    • Measure:
      Positive Lead Measurement / Action Negative Lead
      C3265A-C
      GFD33596Courtesy of FORD MOTOR COMPANY
      		 Ground
      C3265A-D
      GFD33596Courtesy of FORD MOTOR COMPANY
      		 Ground

    Are the resistances greater than 10, 000 ohms? 

    Yes  INSTALL a new seat backrest TED. Refer to Seat Backrest Thermo-Electric Device (TED) . GO to  S11.
    No  REPAIR the affected circuit. GO to  S11.

  8. S8 CHECK THE CUSHION TED CIRCUITS FOR A SHORT TO VOLTAGE

    • Ignition OFF.
    • Disconnect: Passenger Cushion TED C3040 .
    • Ignition ON.
    • Measure:
      Positive Lead Measurement / Action Negative Lead
      C3265A-A
      GFD33595Courtesy of FORD MOTOR COMPANY
      		 Ground
      C3265A-B
      GFD33595Courtesy of FORD MOTOR COMPANY
      		 Ground

    Is any voltage present? 

    Yes  REPAIR the affected circuit. GO to  S11.
    No  INSTALL a new seat cushion TED. Refer to Seat Cushion Thermo-Electric Device (TED) . GO to  S11.

  9. S9 CHECK THE BACKREST TED CIRCUITS FOR A SHORT TO VOLTAGE

    • Ignition OFF.
    • Disconnect: Passenger Backrest TED C3039 .
    • Ignition ON.
    • Measure:
      Positive Lead Measurement / Action Negative Lead
      C3265A-C
      GFD33595Courtesy of FORD MOTOR COMPANY
      		 Ground
      C3265A-D
      GFD33595Courtesy of FORD MOTOR COMPANY
      		 Ground

    Is any voltage present? 

    Yes  REPAIR the affected circuit. GO to  S11.
    No  INSTALL a new seat backrest TED. Refer to Seat Backrest Thermo-Electric Device (TED) . GO to  S11.

  10. S10 CHECK FOR CORRECT DCSM OPERATION

    • Ignition OFF.
    • Disconnect and inspect all DCSM connectors.
    • Repair:
      • corrosion (install new connector or terminals - clean module pins)
      • damaged or bent pins - install new terminals/pins as necessary
      • pushed-out pins - install new pins as necessary
    • Reconnect the DCSM connectors. Make sure they seat and latch correctly.
    • Connect: Passenger Cushion TED C3040 (if previously disconnected).
    • Connect: Passenger Backrest TED C3039 (if previously disconnected).
    • Operate the system and determine if the concern is still present.

    Is the concern still present? 

    Yes  CHECK OASIS for any applicable TSBs. If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no TSBs address this concern, INSTALL a new DCSM. Refer to Dual Climate Controlled Seat Module (DCSM) . GO to  S11.
    No  The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. GO to  S11.

  11. S11 CHECK FOR SRS DTCs

      WARNING: Turn the ignition OFF and wait one minute to deplete the backup power supply. Failure to follow this instruction may result in serious personal injury or death in the event of an accidental deployment.

    • Ignition OFF.

    • Connect: Passenger Seat Side Air Bag C339 .
    • Connect: DCSM C3265A (if previously disconnected).
    • Connect: Passenger Cushion TED C3040 (if previously disconnected).
    • Connect: Passenger Backrest TED C3039 (if previously disconnected).
    • Ignition ON.
    • Using a diagnostic scan tool, clear the RCM DTCs.
    • Cycle the ignition OFF then ON.
    • Using a diagnostic scan tool, perform RCM self-test.

    Are any RCM DTCs retrieved during self-test? 

    Yes  REFER to Supplemental Restraint System for pinpoint test direction.
    No  The repair is complete. RETURN the vehicle to the customer.
scientia non olet · About LEMON Manuals