Safety Belt Buckle - 2nd Row, 40 Percent Seat, with Inflatable Safety Belts: Installation

1.

To install, reverse the removal procedure.

2.

Prove out the SRS : Turn the ignition from ON to OFF. Wait 10 seconds, then turn the ignition back to ON and monitor the air bag warning indicator with the air bag modules installed. The air bag warning indicator illuminates continuously for approximately 6 seconds and then turns off. If a SRS fault is present, the air bag warning indicator:
1. 1.
  
  fails to light.
1. 2.
  
  remains lit continuously.
1. 3.
  
  flashes.
1. 4.
  
  The flashing might not occur until approximately 30 seconds after the ignition has been turned from OFF to ON. This is the time required for the Restraints Control Module to complete the testing of the SRS. If the air bag warning indicator is inoperative and a SRS fault exists, a chime sounds in a pattern of 5 sets of 5 beeps. If this occurs, diagnose and repair the air bag warning indicator and any SRS faults.

3.

Check the active restraint system for correct operation. Refer to Safety Belt System .