Connect the RH parking brake cable to the brake caliper.
3.
Install the 3 parking brake cable bracket bolts.
Tighten to 15 Nm (133 lb-in).
4.
Connect the RH parking brake cable to the LH parking brake cable at the conduit equalizer and position through the wire from bracket.
5.
Connect the cable at the cable-to-cable union.
6.
NOTE:
Make sure that the cable-to-cable union is connected to the front and rear cable before removing the brake control retaining pin and that the cable tension is reloaded slowly.
Remove the parking brake control retaining pin.
7.
Inspect the parking brake system for correct operation.