Parking Brake Control: Installation

1.

Position the parking brake control front cable through the hole and seat the grommet.

2.

Position back the parking brake control onto the studs.

3.

Install the 2 parking brake control bolts.
- Tighten to 30 Nm (22 lb-ft).

4.

Install the parking brake control nut.
- Tighten to 30 Nm (22 lb-ft).

5.

Connect the parking brake switch electrical connector.

6.

Position back the carpet.

7.

Install the scuff plate trim panel and the lower cowl side trim panel. REFER to Interior Trim and Ornamentation

8.

Position the BCM bracket and install the 3 nuts.

9.

Install the BCM. REFER to Multifunction Electronic Modules With Intelligent Access (IA)), REFER to Multifunction Electronic Modules Without Intelligent Access (IA)).

10.

NOTE: Make sure that the cable-to-cable union is connected to the front and rear cable before removing the brake control retaining pin and that the cable tension is reloaded slowly.

Connect the front parking brake cable at the cable-to-cable union and remove the brake control retaining pin.

11.

Inspect the parking brake system for correct operation.