Bumper Cover - Front: Installation

1.

Position the bumper cover and grille assembly to the vehicle.

2.

NOTE: LH side shown in illustration, RH side similar.

Engage the 4 locking tabs on each side of the bumper cover.

GFD37778

Courtesy of FORD MOTOR COMPANY

3.

Install the upper radiator sight shield.
- 1.
  
  Install the 2 pin-type retainers.
- 2.
  
  Install the 7 bolts.
  - Tighten to 3 Nm (27 lb-in).

GFD37777

Courtesy of FORD MOTOR COMPANY

4.

Install the 3 lower bumper cover-to-radiator splash shield bolts.
- 1.
  
  Tighten to 3 Nm (27 lb-in).

GFD37776

Courtesy of FORD MOTOR COMPANY

5.

If equipped, connect the grille flashing LED electrical connector.

6.

If equipped, connect the 2 active park assist electrical connectors.

7.

NOTE: LH side shown in illustration, RH side similar.

Connect the fog lamps electrical connectors.

GFD37775

Courtesy of FORD MOTOR COMPANY

8.

NOTE: LH side shown in illustration, RH side similar.

Install the fender-to-bumper cover screws.
- 1.
  
  Tighten to 3 Nm (27 lb-in).

GFD37774

Courtesy of FORD MOTOR COMPANY

9.

Install the front fender mouldings. REFER to Exterior Trim and Ornamentation .