Bumper Cover - Rear: Installation

1.

Position the bumper cover to the vehicle.

2.

NOTE: LH side shown in illustration, RH side similar.

Install the 2 bumper cover pin-type retainers along the top of the bumper cover.

GFD37781

Courtesy of FORD MOTOR COMPANY

3.

NOTE: LH side shown in illustration, RH side similar.

Install the 2 bumper cover pin-type retainers located in the rear lamp openings.

GFD37780

Courtesy of FORD MOTOR COMPANY

4.

Install the 2 lower bumper cover screws.
- 1.
  
  Tighten to 3 Nm (27 lb-in).

GFD37782

Courtesy of FORD MOTOR COMPANY

5.

Connect the backup sensor electrical connector and install the pin-type retainers.

GFD37783

Courtesy of FORD MOTOR COMPANY

6.

Install the rear lamp assemblies. REFER to Exterior Lighting .

7.

NOTE: LH side shown in illustration, RH side similar.

Install the 3 screws and the pin-type retainer in the wheel opening.
- 1.
  
  Tighten the 3 screws to 3 Nm (27 lb-in).

GFD37779

Courtesy of FORD MOTOR COMPANY

8.

Install the rear fender mouldings. REFER to Exterior Trim and Ornamentation .