Generator - 3.5L Ti-VCT: Removal

WARNING: Before beginning any service procedure in this service information, refer to SAFETY WARNINGS .

1.

NOTE: If equipped, the radial arm adapter is a serviceable item. Do not replace the generator if the radial arm adapter is the only concern.

Disconnect the battery. REFER to Battery, Mounting and Cables .

2.

Remove the cooling fan motor and shroud. REFER to Engine Cooling - 3.5L Ti-VCT.

3.

Rotate the accessory drive belt tensioner clockwise and position the accessory drive belt aside.

4.

Position the generator B+ terminal protective cover aside, remove the nut and position the generator B+ terminal aside.
1. 1.
  
  To install, tighten to 17 Nm (150 lb-in).

5.

Disconnect the generator electrical connector.

6.

Remove the RH fender splash shield. REFER to Front End Body Panels .

7.

Fully loosen the generator bolt.
1. 1.
  
  To install, tighten to 47 Nm (35 lb-ft).

8.

Remove the generator stud nut.
1. 1.
  
  To install, tighten to 47 Nm (35 lb-ft).

9.

Remove the generator stud and the generator.
1. 1.
  
  To install, tighten to 8 Nm (71 lb-in).