Transmission Support Insulator - Anti-Roll: Installation

WARNING: This page is about a different variant/trim than selected.

1.

Clean the roll restrictor through bolts using a wire brush and apply Motorcraft ® Threadlock and Sealer to the threads.

NOTE: If the holes do not line up, check for exhaust bind-up. Relieve exhaust bind-up by moving exhaust vertically and forward and rearward. If the holes still do not line up mount neutralization will have to be performed, REFER to Engine System General Information .

2.
Position the roll restrictor and hand start the roll restrictor through bolts.

Courtesy of FORD MOTOR COMPANY

3.

Tighten the roll restrictor through bolts.
- Torque: 90 Nm (66 lb-ft).

Courtesy of FORD MOTOR COMPANY

4.

Install the engine undershield and the retainers.

Courtesy of FORD MOTOR COMPANY