Transmission - Overhaul: Notes
WARNING: This page is about a different variant/trim than selected.
Special Tool(s)
| Actuator Pin 303-D011 (D80L-100-G) | |
| Collet, 3/4 Inch to 7/8 Inch 303-D019 (D80L-100-Q) | |
| Compressor, Center Support Piston Spring 307-630 | |
| Compressor, Forward Clutch Spring 307-574 (includes 307-574/1 and 307-574/2) | |
| Compressor, Forward/Intermediate Spring 307-584 (includes 307-584/1 and 307-584/2) | |
| Compressor, Overdrive Clutch, Balance Piston and Direct Clutch 307-589 (includes 307-589/1 and 307-589/2) | |
| Dial Indicator Gauge With Holding Fixture 100-002 (TOOL-4201-C) | |
| Handle 205-153 (T80T-4000-W) | |
| Handle, Torque Converter 307-091 (T81P-7902-C) | |
| Holding Fixture 307-625 | |
| Holding Fixture, Transmission 307-003 (T57L-500-B) | |
| Input Shaft Support Seal Installer (Back Plate, Multiple Rings) 307-578 (includes 307-578/1, 307-578/2 and 307-578/3) | |
| Installer, Axle Seal 307-718 | |
| Installer, Converter Seal 307-627 | |
| Installer, Differential Seal 307-626 | |
| Leak Tester, Torque Converter 307-691 | |
| Manual Lever Seal Installer 307-581 | |
| Remover, Roll Pin 211-061 (T78P-3504-N1) | |
| Retainer, Torque Converter 307-566 | |
| Slide Hammer 100-001 (T50T-100-A) | |
| Seal Installer, Turbine Shaft 307-723 | |
| Seal Protector, 2-6 Piston 307-632 | |
| Seal Protector, Low Reverse Piston 307-628 (includes 307-628/1 and 307-628/2) | |
| Seal Protector, Low Reverse / 1-2-3-4 Piston 307-629 | |
| Seal Protector, Turbine Shaft 307-635 | |
| Shim Selection Gauge 307-300 (T94P-77000-Q) (17-055) | |
| Spring Compressor, 2-6 Piston Return 307-633 (Includes 307-633/1 and 307-633/2) | |
| Tool Kit, Torque Converter Flusher 307-732 |
Material
| Item | Specification |
| Motorcraft ® MERCON ® LV Automatic Transmission Fluid XT-10-QLVC (US); CXT-10-LV12 (Canada) | MERCON ® LV |
| Ultra Silicone Sealant TA-29 | - |