Pinpoint Test AK : U0155:00
- WARNING: Do not handle, move or change the original horizontal mounting position of the restraints control module (RCM) while the RCM is connected and the ignition switch is ON. Failure to follow this instruction may result in the accidental deployment of the Safety Canopy and cause serious personal injury or death.
- NOTE: Most faults are due to connector and/or wiring concerns. Carry out a thorough inspection and verification before proceeding with the pinpoint test.
- NOTE: SRS components should only be disconnected or reconnected when instructed to do so within a pinpoint test step. Failure to follow this instruction may result in incorrect diagnosis of the SRS.
- NOTE: Always make sure the correct SRS component is being installed. Parts released for other vehicles may not be compatible even if they appear physically similar. Check the part number listed in Ford Catalog Advantage™ or equivalent to make sure the correct component is being installed. If an incorrect SRS component is installed, DTCs may set.
- NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- AK1 CHECK THE COMMUNICATION NETWORK
- Ignition ON.
- Using a scan tool, carry out the network test.
Does the IPC pass the network test?
Yes GO to AK2. No Go to Pinpoint Test H to diagnose no communication with the IPC. - AK2 CHECK THE RCM CMDTCs
- Ignition ON.
- Using a scan tool, perform RCM self-test to retrieve DTCs.
- Clear the DTCs.
- Wait 10 seconds.
- Repeat the RCM self-test.
Is DTC U0155:00 retrieved again?
Yes GO to AK3. No The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition. - AK3 RETRIEVE THE RECORDED DTCs FROM THE RCM SELF-TEST
- Check for recorded DTCs from the RCM self-test.
Is DTC U3003:16 or U3003:17 recorded?
Yes GO to Pinpoint Test Y . No GO to AK4. - AK4 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST
- Check for recorded DTCs from the IPC self-test.
Is DTC U3003:16 or U3003:17 recorded?
Yes For DTC U3003:16, Go to Pinpoint Test BD . For DTC U3003:17, Go to Pinpoint Test BE . No GO to AK5. - AK5 CHECK FOR DTC U0155:00 SET IN OTHER MODULES
- Ignition ON.
- Using the scan tool, perform the self-test for all modules.
- Retrieve the CMDTCs from all modules.
Is DTC U0155:00 set in the C-CM, FCIM, or APIM ?
Yes CHECK OASIS for any applicable TSBs. If a TSB exists for this concern, discontinue this test and follow TSB instructions. If no TSBs address this concern, refer to IPC Hardware Testing . No CHECK OASIS for any applicable TSBs. If a TSB exists for this concern, discontinue this test and follow TSB instructions. If no TSBs address this concern, INSTALL a new RCM. REFER to Restraints Control Module (RCM) .