Crankshaft Pulley: Installation

1.

Lubricate the crankshaft front seal inner lip and crankshaft pulley outside diameter sealing surfaces with clean engine oil.

GFD34573

Courtesy of FORD MOTOR COMPANY

2.

Using 303-102 T74P-6316-B and 303-335 T88T-6701-A, install the crankshaft pulley.

GFD34574

Courtesy of FORD MOTOR COMPANY

3.

Using strap wrench, install the crankshaft pulley washer and new bolt and tighten in 4 stages.
- Stage 1: Tighten to 120 Nm (89 lb-ft).
- Stage 2: Loosen one full turn.
- Stage 3: Tighten to 50 Nm (37 lb-ft).
- Stage 4: Tighten an additional 90 degrees.

GFD34575

Courtesy of FORD MOTOR COMPANY

4.

Install the accessory drive belt. REFER to Accessory Drive .

5.

Install the RH splash shield. REFER to Front End Body Panels .

6.

After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.