Auto-Unlock Programming

Programming the Auto-Unlock Feature Using the Keyless Entry Keypad 

1. 1.
   
   Place the ignition in the OFF mode and close all vehicle doors.

1. 2.
   
   Enter the factory set 5-digit keyless entry keypad code.

1. 3.
   
   Press and hold the 3/4 button on the keypad. While holding the 3/4 button, press and release the 7/8 button. While still holding the 3/4 button, press and release the 7/8 button a second time.

1. 4.
   
   Release the 3/4 button. The horn chirps once if auto-unlock is disabled or twice (one short chirp followed by a honk) if auto-unlock is enabled.

Programming the Auto-Unlock Feature Using the Message Center 

1. 1.
   
   With all the vehicle doors closed, place the ignition in the ON mode.

1. 2.
   
   
   NOTE: Refer to the Owner's Literature a complete list of the message center menus.

   Access the locks menu within the setup menu in the message center.

1. 3.
   
   Select auto-unlock and use the left and right arrows to enable or disable the feature.