Removal And Installation: Flexplate: Installation

NOTE: One of the 8 flexplate holes are offset so the flexplate can only be installed in one position.
1. 1.
   Install the flexplate and the 8 bolts.
   • Tighten in the sequence shown to 80 Nm (59 lb-ft).

Fig 1: Flexplate Bolts Tightening Sequence

Courtesy of FORD MOTOR CO.

1. 2.
   
   Install the transaxle. REFER to Automatic Transmission 6F50 6F55 - Front Wheel Drive (FWD) or REFER to Automatic Transmission 6F50 6F55 - All Wheel Drive (AWD). .

1. 3.
   
   After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.