Cruise-Control Module (C-CM): Removal

NOTE: If installing a new C-CM, it is necessary to upload the module configuration information into the scan tool prior to removing the module. This information must be downloaded into the new module after installation.

1.

If installing a new C-CM, upload the module configuration information from the C-CM into the scan tool by following the scan tool on-screen instructions.

2.

Remove the front bumper cover. REFER to Bumpers .

3.

Gently pry the C-CM away from the retaining studs.
1. 1.
  
  Disconnect the electrical connector.

4.

If required, remove the 3 bolts and the C-CM bracket assembly.

5.

Inspect the C-CM grommets for any damage and install new grommets as necessary.