Pinpoint Test Z : The IPC Infotainment Display Is Inoperative
- Z1 CHECK THE INFOTAINMENT DISPLAY
- Ignition ON.
- Check the RH infotainment display in the IPC.
Is the display blank?
Yes Refer to IPC Hardware Testing . No GO to Z2. - Z2 CHECK FOR DTCs FROM THE SCCM SELF-TEST
- Using a diagnostic scan tool, perform the SCCM self-test.
Are any DTCs related to the RH steering wheel switch present?
Yes GO to Pinpoint Test V . No GO to Z3. - Z3 CHECK FOR DTCs FROM THE IPC SELF-TEST
- Using a diagnostic scan tool, perform the IPC self-test.
Is DTC U0212:00 present?
Yes Refer to article 'Instrumentation, Message Center, and Warning Chimes', Go to Pinpoint Test AZ . No GO to Z4. - Z4 CHECK FOR CORRECT SCCM OPERATION
- Ignition OFF.
- Disconnect and inspect all the SCCM connectors.
- Repair:
- Corrosion (clean module pins or install new connectors or terminals)
- Damaged or bent pins (install new terminals or pins)
- Pushed-out pins (install new pins as necessary)
- Reconnect all the SCCM connectors. Make sure they seat and latch correctly.
- Operate the system and determine if the concern is still present.
Is the concern still present?
Yes CHECK OASIS for any applicable TSBs. If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no TSBs address this concern, INSTALL a new SCCM. REFER to Steering Column Switches . No The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.