Washer Pump and Reservoir: Removal

WARNING: Carefully read cautionary information on product label. For emergency medical information seek medical advice. In the USA or Canada on Ford/Motorcraft products call the Poison Control Center at: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

NOTE: To prevent spilling washer fluid, drain the washer reservoir before removal.

1.

Remove the washer reservoir cap from the washer reservoir.

2.

Remove the RF fender splash shield. REFER to Front End Body Panels .

3.

NOTE: Front bumper cover removed for clarity.

Disconnect the washer pump and washer level sensor electrical connectors and disconnect the wire pin-type retainer from the washer reservoir.

Courtesy of FORD MOTOR COMPANY

4.

NOTE: Front bumper cover removed for clarity.

Disconnect the washer pump hoses.

Courtesy of FORD MOTOR COMPANY

5.

NOTE: Front bumper cover removed for clarity.

Remove the 2 washer reservoir nuts and the washer reservoir bolt.
- To install, tighten to 9 Nm (80 lb-in).

Courtesy of FORD MOTOR COMPANY

6.

NOTE: Front bumper cover removed for clarity.

Pull the washer reservoir off of the studs and remove the washer reservoir through the RF wheel well.

Courtesy of FORD MOTOR COMPANY