Removal And Installation

WARNING: This page is about a different variant/trim than selected.

WARNING: Before beginning any service procedure in this service information, refer to SAFETY WARNINGS .

WARNING: Before working on or disconnecting any of the fuel tubes or fuel system components, relieve the fuel system pressure to prevent accidental spraying of fuel. Fuel in the fuel system remains under high pressure, even when the engine is not running. Failure to follow this instruction may result in serious personal injury.

WARNING: Clean all fuel residue from the engine compartment. If not removed, fuel residue may ignite when the engine is returned to operation. Failure to follow this instruction may result in serious personal injury.

NOTE: Removal steps in this procedure may contain installation details.

1.

Tighten to 5 Nm (44 lb-in).

Courtesy of FORD MOTOR COMPANY

Courtesy of FORD MOTOR COMPANY

3.

Tighten to 10 Nm (89 lb-in).

Courtesy of FORD MOTOR COMPANY

Courtesy of FORD MOTOR COMPANY

5.

NOTE: Make sure that the mating faces are clean and free of foreign material.

To install, reverse the removal procedure.