Roof Opening Panel Alignment - Front
General Procedure
NOTE:
The roof opening panel motor(s) must be initialized when repairs are carried out on any part of the roof opening panel system, including whenever:
- the roof opening sliding glass or power shade motor has been removed from the roof opening panel system.
- the roof opening panel glass has been removed from the roof opening panel system.
- the roof opening panel assembly has been removed from the vehicle.
- a new roof opening sliding glass or power shade motor has been installed.
- a new roof opening panel glass has been installed.
- a new roof opening panel assembly has been installed.
Refer to Roof Opening Panel Motor Initialization - Sliding Glass Panel and Refer to Roof Opening Panel Motor Initialization - Shade .
NOTE:
If both glass panels are being aligned, align the rear fixed glass panel before aligning the front sliding glass panel. Refer to Roof Opening Panel Alignment - Rear .
- 1.
Position the front sliding glass panel to the fully CLOSED position and the power shade to the full OPEN position.
- 2.
Unclip the top portion of the concertina blind and slide the concertina blind rearward as necessary to access the glass panel screws.
- 4.
Adjust the front sliding glass panel to specifications.- Measure 12 inches from the left of the vehicle centerline and then repeat to the right of the vehicle centerline at all three locations shown in above illustration.
- 5.
Using a 0.3 mm (0.0118 in) thick shim or similar tool, slide it around the perimeter of the glass panel to check for even tension and seal contact.
- 7.
Initialize the sliding glass panel and power shade motors. Refer to Roof Opening Panel Motor Initialization - Sliding Glass Panel and Refer to Roof Opening Panel Motor Initialization - Shade .