PINPOINT TEST L : The Visual Park Aid Alert Is Inoperative
- L1 VERIFY THE VISUAL PARK AID IS ENABLED
- Verify that the visual park aid is enabled using the FDIM.
Is the visual park aid is enabled in the FDIM ?
Yes GO to L2. No ENABLE the visual park aid. - L2 CHECK FOR DTCs FROM THE PAM SELF-TEST
- Ignition ON.
- Using a scan tool, perform the PAM self-test.
Are any PAM DTCs present?
Yes Refer to Parking Aid . No GO to L3. - L3 CHECK FOR DTCs FROM THE BCM SELF-TEST
- Ignition ON.
- Using a scan tool, perform the BCM self-test.
Are any BCM DTCs present?
Yes REFER to Multifunction Electronic Modules . No GO to L4. - L4 CHECK FOR CORRECT VIDEO CAMERA OPERATION
- Disconnect the video camera connector.
- Check for:
- corrosion (install new connector or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary
- Reconnect the video camera connector. Make sure it seats and latches correctly.
- Operate the system and determine if the concern is still present.
Is the concern still present?
Yes INSTALL a new video camera. Refer to Video Camera . No The system is operating correctly at this time. The concern may have been caused by the video camera connection. ADDRESS the root cause of any connector or pin issues.