Azimuth System Check

General Procedure

NOTE: The scan tool may be used to monitor distance PIDs. The distance PIDs read between 0 and 255 cm (0 and 8 ft) on a correctly functioning system.

NOTE: The parking aid system defaults to on when the ignition key is cycled from OFF to ON.

NOTE: The following system check should be carried out with the vehicle on a level surface. The specified object locations are approximate, not absolute.

NOTE: The object used in this system check can be fabricated from 76.2 mm (3 in) OD 990.6 mm (39 in) length pipe (from a hardware or plumbing supply).

1.
Turn the ignition to the ON position, engine off.

Courtesy of FORD MOTOR COMPANY

2.

Set the parking brake on.

3.

Place the gear shift in REVERSE (R).

4.

Verify that the parking aid system detects the specified object when placed within the 5 specified locations (P1, P2, P3, P4, P5). The pipe should be inside of these locations.
1. 1.
  
  The speaker should beep slowly when objects are detected on the outer edges of the detection zone, and increase as the object is moved closer to the vehicle. When the object is within 457.2 mm (18 in) of the rear bumper, the sounder should be on continuously
1. 2.
  
  If the parking aid system does not detect the object, refer to Parking Aid , Symptom Chart: Parking Aid - Audible.