Toe Adjustment - Front

General Procedure 

• 1.
  
  Using alignment equipment and the manufacturer's instructions, measure the front toe.

• 2.
  
  Start the engine and center the steering wheel.

• 3.
  
  Turn the engine off and, using a suitable steering wheel holding device, lock the steering wheel in the straight-ahead position.

• 4.
  
  Remove the steering gear bellows clamps.

Courtesy of FORD MOTOR COMPANY

• 5.
  
  Loosen the tie-rod end jam nuts (1 each side).

Courtesy of FORD MOTOR COMPANY

• 6.
  
  
  NOTE: Do not allow the steering gear bellows to twist when the tie rod is rotated.

  Rotate the tie rods as necessary to adjust the toe setting.

• 7.
  
  Tighten the tie-rod end jam nuts.
  • Tighten to 63 Nm (46 lb-ft).

Courtesy of FORD MOTOR COMPANY

• 8.
  
  Recheck the toe settings and adjust as necessary.

• 9.
  
  Install the steering gear bellows clamps.