Body Control Module (BCM) - With Intelligent Access (IA): Installation

1.

Install the BCM and connect the electrical connectors.

2.

Install the steering column opening trim panel.

NOTE: Carry out the remaining steps only if installing a new BCM.

NOTE: If the ignition is left in RUN or ACC and the engine is OFF during the vehicle battery charging process, the Battery Monitoring System (BMS) can turn off the ignition causing the configuration to fail.

3.
After battery charging is complete, carry out the BMS reset by following the scan tool on screen instructions.

NOTE: Once the BCM Programmable Module Installation (PMI) is complete, follow the scan tool on-screen instructions for performing the Configurable Engine Immobilizer (CEI) lock configuration.

4.
Download the BCM configuration information from the scan tool to the new BCM by following the scan tool on screen instructions.

5.

Carry out the parameter reset procedure. REFER to Passive Anti-Theft System (PATS), With Intelligent Access (IA) .

6.

Train the tire pressure sensors. REFER to Tire Pressure Monitoring System (TPMS) .

NOTE: If the dome lamps are flashing after BCM installation, it was not configured completely. Repeat steps 3 through 6.

7.
Carry out the BCM self-test to confirm all DTCs have been cleared.

8.

Carry out the keyless entry keypad code reset. Refer to Keyless Entry Keypad Code Programming. REFER to Handles, Locks, Latches and Entry Systems With Intelligent Access (IA) .