Maintenance Service Reminder Reset - Procedure 03

A SRI is used to indicate emission system maintenance is required. Control unit (timer) for maintenance light is located under dash, near steering column or behind glove box. Some models use a non-resettable control unit. Replace it with a resettable type. After servicing emission system, reset SRI.

1. To reset SRI, turn ignition off. Remove tape over reset hole in timer. Lightly push a small Phillips screwdriver into hole in timer unit marked RESET. With light pressure on screwdriver, turn ignition switch to RUN position.
2. Light should stay on while screwdriver is pressed down. Hold screwdriver down for approximately 5 seconds. Remove screwdriver. Light should go out within 2-5 seconds. If light does not go out, repeat step  1
3. Cycle ignition from OFF to RUN position. Light should glow for 2-5 seconds. This verifies proper reset of maintenance reminder light.