Body Control Module (BCM) - Without Intelligent Access (IA): Installation

1.

Install the BCM and connect the electrical connectors.

2.

Install the steering column opening trim panel.

NOTE: Carry out the remaining steps only if installing a new BCM.

NOTE: All vehicle keys are erased during the parameter reset procedure. Verify at least 2 of the vehicle keys are available prior to continuing with this procedure.

3.

Download the module configuration information from the scan tool to the new BCM by following the scan tool on-screen instructions.

NOTE: Once the BCM Programmable Module Installation (PMI) is complete, follow the scan tool on-screen instructions for performing the Configurable Engine Immobilizer (CEI) lock configuration.

4.
Download the BCM configuration information from the scan tool to the new BCM by following the scan tool on screen instructions.

5.

Carry out the parameter reset procedure. REFER to Passive Anti-Theft System (PATS), Without Intelligent Access (IA) .

6.

Carry out the key programming procedure. REFER to Passive Anti-Theft System (PATS), Without Intelligent Access (IA) .

7.

Train the tire pressure sensors. REFER to Tire Pressure Monitoring System (TPMS) .

NOTE: If the dome lamps are flashing after BCM installation, it was not configured completely. Repeat steps 3 through 7.

8.
Carry out the BCM self-test to confirm all DTCs have been cleared.