ATEQ TPMS Reset Procedure (Intelligent Access - IA)

NOTE: This procedure is for models with the Intelligent Access (IA) type of Remote Keyless Entry system.

Set the tire pressure of all wheels to pressure specified on the tire and loading information label.
Close All Doors.
Turn START/STOP button to OFF position, then press and release brake pedal.
Using the START/STOP button, switch from OFF to ACCESSORY to RUN position 3 times, ending in RUN position.
Press and release the brake pedal.
Turn START/STOP button to OFF position.
Using the START/STOP button, switch from OFF to ACCESSORY to RUN position 3 times, ending in RUN position.
Place TPM3 on the left front tire wall at the valve stem. Press the "TEST" button. The horn will sound briefly to indicate that the tire pressure sensor has been recognized.
Within 2 minutes after the horn sounds, place TPMS3 on the right front tire wall at the valve stem. Then press the test button to train the right front tire pressure sensor. Repeat procedure for right rear and left rear tires.
When the tire training procedure is complete, the message center (if equipped) will display "TIRE TRAINING COMPLETE". For vehicles not equipped with a message center, successful completion of the training procedure will be verified by turning the ignition switch to the OFF position without the horn sounding. If the horn sounds twice when Start/Stop button is turned off, the training procedure was not successful.