Ignition Coil-On-Plug - RH: Installation

1.

Inspect the ignition coil-on-plug seals for rips, nicks or tears. Remove and discard any damaged ignition coil-on-plug seals.
- To install, slide the new ignition coil-on-plug seal onto the ignition coil-on-plug until it is fully seated at the top of the coil-on-plug.

GFD34993

Courtesy of FORD MOTOR COMPANY

2.

NOTE: Apply a small amount of silicone brake caliper grease and dielectric compound to the inside of the ignition coil-on-plug boots before installation.

Install the 3 RH ignition coil-on-plugs.

3.

Install the 3 RH ignition coil-on-plug bolts.
- Tighten to 7 Nm (62 lb-in).

4.

Connect the 3 RH ignition coil-on-plug electrical connectors.

5.

Install the upper intake manifold, refer to ENGINE - 3.5L TI-VCT .