Throttle Position (TP) Sensor - 3.5L GTDI: Removal
- 1.
Remove the CAC outlet pipe. REFER to Intake Air Distribution and Filtering .
- 3.
- 1.NOTE: Do not put direct heat on the TP sensor or any other plastic parts because heat damage may occur. Damage may also occur if ETB temperature exceeds 120°C (248°F).NOTE: Do not use power tools.
Using a heat gun, apply heat to the top of the ETB until the top TP sensor bolt ear reaches approximately 55°C (130°F). This should take no more than 3 minutes using a 1, 100-watt heat gun. The heat gun should be about 25.4 mm (1 in) away from the ETB.
- 2.
Monitor the temperature of the top TP sensor bolt ear on the ETB with a digital temperature laser or infrared thermometer, while heating the ETB.
- 3.
Using hand tools, quickly remove the bolt farthest from the heat source first.
- 4.
Using hand tools, remove the remaining bolt.
- 5.
Remove the TP sensor.
- 1.
