PINPOINT TEST O : The Stability-Traction Control Disabled Indicator (Sliding Car OFF Icon) Is Never or Always On
- O1 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST
- Using a scan tool, perform the IPC self-test.
Are any DTCs recorded?
Yes For DTC U0121:00, GO to Pinpoint Test AU . For all other DTCs, REFER to DTC Chart: IPC . No GO to O2. - O2 RETRIEVE THE RECORDED DTCs FROM THE ABS MODULE SELF-TEST
- Using a scan tool, perform the ABS module self-test.
Are any DTCs recorded?
Yes REFER to Anti-Lock Brake System (ABS) and Stability Control . No GO to O3. - O3 CHECK FOR THE KEY TYPE
- Check if the key is the MyKey ® programmed key or an administrator key. Refer the Owners Literature.
Is the key an administrator key?
Yes GO to O4. No If the MyKey ®AdvanceTrac ® on feature is configured always on, the system is normal. The stability-traction control system cannot be disabled when the AdvanceTrac ® on feature is configured always on. If the MyKey ®AdvanceTrac ® on feature is not configured always on, GO to O4. - O4 CHECK THE TRACTION CONTROL SETTING THROUGH THE MESSAGE CENTER
- Using the LH steering wheel switch, navigate to the traction control setting menu and observe the traction control setting.
- Configure the stability-traction control on then off again.
Does the traction control selection change when the feature is configured on and off?
Yes GO to O5. No Refer to IPC Hardware Testing . - O5 CARRY OUT THE IPC INDICATOR LAMP CONTROL ACTIVE COMMAND USING THE SCAN TOOL
- Ignition ON.
- Using a scan tool, view the IPC PIDs.
- Select the IPC stability-traction control disabled indicator (sliding car OFF icon) PID (STAB_TC_LMP). Command the stability-traction control disabled indicator (sliding car OFF icon) on and off while observing the stability-traction control disabled indicator (sliding car OFF icon).
Does the stability-traction control disabled indicator (sliding car OFF icon) illuminate when commanded on and turn off when commanded off?
Yes INSTALL a new ABS module. REFER to Anti-Lock Brake System (ABS) and Stability Control . No Refer to IPC Hardware Testing .