LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2015 >> Explorer Limited, 3.5L Eng VIN 8, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seating System - 1ST Row >> Removal And Installation >> Seat Cushion Heater Mat >> Removal

Seat Cushion Heater Mat: Removal

NOTE: The passenger seat is equipped with an OCS bladder system, to prevent system failure, it is necessary to carry out the OCS reset when a front passenger seat cushion is disassembled, a new cushion cover is installed or an OCS service kit is installed. A scan tool is used to carry out the OCS reset.
NOTE: Do not reinstall any heater mat after removal. The adhesive will not adhere correctly, causing it to bunch up or shift out of place. A new heater mat and a new foam pad must be installed. If a new heater mat is needed for a passenger seat cushion, an OCS service kit must be installed. Failure to follow these instructions can result in heated seat component damage, system failure or incorrect OCS operation.
NOTE: The passenger seat is equipped with an OCS bladder system, a new OCS service kit and a new cushion heated seat mat must be installed. REFER to Supplemental Restraint System .
NOTE: An OCS bladder system and the Occupant Classification System (OCS) service kit has the electrical connector glued to the OCSM. It cannot and should not be disconnected or altered.
NOTE: For component identification and locations, refer to Seat - Exploded View, Front .
    NOTE: All Seats

  1. 1.
    For a passenger seat equipped with a OCS service kit, remove the OCS sensor. For additional information, REFER to Supplemental Restraint System .

  1. 2.

    Remove the seat cushion cover. For additional information, refer to Seat Cushion Cover .
    NOTE: Note the wire harness routing for installation.

  1. 3.
    At the front of the seat track, disconnect the cushion heater mat electrical connector and separate the wire harness retainer.
GFD37474Courtesy of FORD MOTOR COMPANY

  1. 4.

    Remove the cushion foam pad from the cushion frame. Discard the cushion foam pad with heater mat.
    NOTE: Power seat track on top, manual seat track on bottom.

  1. 5.
    For a passenger seat, remove the OCSM in the following sequence:
    • Disconnect the electrical connector.
      NOTE: For manual seat track only.
    • If equipped, bend the locking tab downward.
    • Remove the 2 screws.
GFD37475Courtesy of FORD MOTOR COMPANY
    NOTE: Power seat track on top, manual seat track on bottom.

  1. 6.
    For a passenger seat, separate the pressure sensor in the following sequence:
    • Bend the locking tab downward.
    • Slide the pressure sensor off of the bracket.
    • Disconnect the electrical connector.
GFD37476Courtesy of FORD MOTOR COMPANY

  1. 7.

    For a passenger seat, detach the OCS bladder pin-type retainers.
GFD37477Courtesy of FORD MOTOR COMPANY
    NOTE: Power seat track on top, manual seat track on bottom.

  1. 8.
    For a passenger seat, route the OCS hose and pressure sensor through the cushion support wires.
GFD37478Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals