Universal Serial Bus (USB) Cable - Lower: Removal

WARNING: Before beginning any service procedure in this article, refer to SERVICE INFORMATION

1. 1.
   
   Position the RF seat fully rearward and fully reclined.

1. 2.
   
   Remove the RH floor console side trim panel.

   1. 1.
      
      Pull outward to release the 12 clips.

Courtesy of FORD MOTOR COMPANY

1. 3.
   
   Remove the LH and RH finish panel. REFER to Instrument Panel and Console .

1. 4.
   
   Pull the LH floor console side trim panels outward to release the top 3 retaining clips. REFER to Instrument Panel and Console .

1. 5.
   
   Position the arm rest latch trim panel aside.

   1. 1.
      
      Pull upward to release the 2 clips.

Courtesy of FORD MOTOR COMPANY

1. 6.
   
   Remove the screw for the console upper finish panel.

Courtesy of FORD MOTOR COMPANY

1. 7.
   
   Position the floor console selector lever to the full rearward position.

1. 8.
   
   Position aside the console upper finish panel from the floor console.

   1. 1.
      
      Pull upward to release the clips starting at the rear and working forward.

Courtesy of FORD MOTOR COMPANY

1. 9.
   
   Disconnect the lower USB cable from the upper USB cable.

Courtesy of FORD MOTOR COMPANY

1. 10.
   
   Remove the lower USB cable.

   1. 1.
      
      Disconnect the lower USB cable from the USB port.

   1. 2.
      
      Disconnect the 3 pin-type retainers.

Courtesy of FORD MOTOR COMPANY