PINPOINT TEST C : All Dimmable Non-Networked Illumination Is Always On

NOTE: Make sure the headlamp switch is in the off position.

C1 CHECK THE PARKING LAMP OPERATION

Ignition OFF.

Wait 1 minute and observe the parking lamps.

Are the parking lamps illuminated?

Yes	Refer to article 'Exterior Lighting', Go to Pinpoint Test U .
No	GO to C2.

C2 CHECK THE BCM DIMMABLE BACKLIGHTING OUTPUT CIRCUIT FOR A SHORT TO VOLTAGE
- Disconnect: BCM C2280B.
- Ignition ON.
Do the dimmable backlighted components continue to illuminate?

Yes REPAIR the circuit.

No GO to C3.

C3 CHECK FOR CORRECT BCM OPERATION

Disconnect and inspect all BCM connectors.

Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary

Reconnect the BCM connectors. Make sure they seat and latch correctly.

Operate the system and determine if the concern is still present.

Is the concern still present?

Yes	CHECK OASIS for any applicable TSBs. If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no TSBs address this concern, INSTALL a new BCM. REFER to Multifunction Electronic Modules or REFER to Multifunction Electronic Modules .
No	The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.