Parking Aid Module (PAM): Removal

NOTE: Module configuration is required when a new PAM is being installed.

1.
Upload the module configuration information from the PAM into the scan tool by following the instructions on the scan tool.

2.

Position aside the liftgate weatherstrip.

NOTE: To avoid damage to the liftgate scuff plate trim panel, remove any retaining clips from the body and attach them to the liftgate scuff plate trim panel before installing.

3.
Remove the liftgate scuff plate trim panel.
1. 1.
  
  Pull upward to release the retaining clips.

GFD37097

Courtesy of FORD MOTOR COMPANY

NOTE: To avoid damage to the scuff plate trim panel, remove any retaining clips from the body and attach them to the scuff plate trim panel before installing.

4.
Remove the rear RH door scuff plate trim panel.
1. 1.
  
  Pull upward on the scuff plate trim panel to release the retaining clips.

GFD37098

Courtesy of FORD MOTOR COMPANY

5.

Remove the RH quarter trim panel retaining push pin.

GFD37099

Courtesy of FORD MOTOR COMPANY

6.

Position the RH second row seat in the flat position and then tilt the second row seat forward.

7.

Position the RH third row seat in the flat position.

8.

Remove the RH cargo retaining hooks.

GFD37100

Courtesy of FORD MOTOR COMPANY

NOTE: To avoid damage to the quarter trim panel, remove any retaining clips from the body and attach them to the quarter trim panel before installing.

9.
Position the RH quarter trim panel aside.
1. 1.
  
  Pull the RH quarter trim panel toward the inside of the vehicle to release the retaining clips

GFD37101

Courtesy of FORD MOTOR COMPANY

10.

Remove the 2 bolts and remove the PAM.
1. 1.
  
  To install, tighten to 3 Nm (27 lb-in).
1. 2.
  
  Disconnect the electrical connector.

GFD38137

Courtesy of FORD MOTOR COMPANY