Front Fog Lamp Adjustment
General Procedure
WARNING:
Before beginning any service procedure in this article, refer to Safety Warnings in SERVICE INFORMATION
.
NOTE:
Horizontal aim is not required for this vehicle and is not adjustable. Consult your state vehicle inspection center for recommended tolerance ranges for visual aiming.
- 1.
Before starting the fog lamp assembly adjustment:- 1.
check the tire inflation.
- 2.
make sure there are no other loads in the vehicle other than a half tank of fuel.
- 3.
make sure the vehicle is on level ground.
- 4.
make sure the fog lamps and headlamps are clean.
- 5.
make sure the headlamps are operating and are correctly aimed.
- 1.
- 2.
Park the vehicle on a level surface approximately 7.62 m (25 ft) from the vertical wall or screen directly in front of it.
NOTE:
The vertical wall screen must be a minimum of 2.44 m (8 ft) wide.
- 3.
The correct visual aim for the fog lamps is with the top edge of the high-intensity zone 101.6 mm (4 in) below the horizontal center of the fog lamps. Adjust the fog lamps as necessary.
