Pinpoint Test G : The LF Door Speaker Is Inoperative Or Has Poor Sound Quality
- G1 CHECK THE AUDIO SIGNAL TO THE LF DOOR SPEAKER
- Ignition OFF.
- Disconnect: LF Door Speaker C523 .
- Operate the audio system in radio tuner AM/FM mode.
Is a fluctuating AC voltage present?
Yes INSTALL a new LF door speaker. REFER to Speaker - Door . No GO to G2. - G2 CHECK THE AUDIO CIRCUITS TO THE LF DOOR SPEAKER FOR A SHORT TO VOLTAGE
- Ignition OFF.
- Disconnect: ACM C240A .
- Ignition ON.
Is any voltage present?
Yes REPAIR the circuit in question. No GO to G3. - G3 CHECK THE AUDIO CIRCUITS TO THE LF DOOR SPEAKER FOR A SHORT TO GROUND
- Ignition OFF.
Are the resistances greater than 10, 000 ohms?
Yes GO to G4. No REPAIR the circuit in question. - G4 CHECK THE AUDIO CIRCUITS FOR A SHORT TOGETHER
- Disconnect: LF Tweeter Speaker C513 .
Are the resistances greater than 10, 000 ohms?
Yes GO to G5. No REPAIR the circuits in question. - G5 CHECK THE AUDIO CIRCUITS TO THE LF DOOR SPEAKER FOR AN OPEN
Are the resistances less than 3 ohms?
Yes GO to G6. No REPAIR the circuit in question. - G6 CHECK FOR CORRECT ACM OPERATION
- Ignition OFF.
- Disconnect and inspect all ACM connectors.
- Repair:
- Corrosion (clean module pins or install new connectors or terminals)
- Damaged or bent pins (install new terminals or pins)
- Pushed-out pins (install new pins as necessary)
- Reconnect the ACM connectors. Make sure they seat and latch correctly.
- Operate the system and determine if the concern is still present.
Is the concern still present?
Yes CHECK OASIS for any applicable TSBs. If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no TSBs address this concern, INSTALL a new ACM. REFER to Audio Control Module (ACM) . No The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.


