LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2015 >> Explorer Limited, 3.5L Eng VIN 8, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Information And Entertainment Systems - SONY Sound >> Diagnosis And Testing >> Information and Entertainment System - Sony Sound >> DTC Charts >> DTC Chart: FCIM - Sony Sound

DTC Chart: FCIM - Sony Sound

Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to Diagnostic Methods in Service Information for information about these practices.

DTC Description Action
B00D5:01 Restraint System Passenger Disable Indicator: General Electrical Failure CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC B00D5:01 is still present, INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM) .
B113C:11 Hazard Switch Illumination: Circuit Short To Ground CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC B113C:11 is still present, INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM) .
B1202:01 Restraint System Passenger Enable Indicator: General Electrical Failure CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC B1202:01 is still present, INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM) .
U0155:00 Lost Communication With IPC Module: No Sub Type Information GO to Pinpoint Test AD .
U0423:00 Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information REFER to Instrumentation, Message Center, and Warning Chimes to RETRIEVE and FOLLOW DTCs present in the IPC.
U2013:63 Switch Pack: Circuit/Component Protection Time-Out GO to Pinpoint Test X .
U201A:51 Control Module Main Calibration Data: Not Programmed DTC U201A:51 sets when the FCIM calibration is missing or corrupted. INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM) .
U3000:41 Control Module: General Checksum Failure CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC U3000:41 is still present, INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM) .
U3000:42 Control Module: General Memory Failure CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC U3000:42 is still present, INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM) .
U3003:16 Battery Voltage: Circuit Voltage Below Threshold GO to Pinpoint Test AJ .
U3003:17 Battery Voltage: Circuit Voltage Above Threshold GO to Pinpoint Test AK .
scientia non olet · About LEMON Manuals