Lumbar Assembly - Power: Installation

1.

if equipped, position the TED duct between the power lumbar and cable.

GFD37437

Courtesy of FORD MOTOR COMPANY

2.

Install the power lumbar retaining clips to backrest frame and connect the power lumbar motor.

GFD37436

Courtesy of FORD MOTOR COMPANY

3.

If equipped, connect the backrest TED electrical connector and engage the pin-type retainer.

GFD37435

Courtesy of FORD MOTOR COMPANY

4.

Position the backrest cover down and install new first row hog rings.

5.

Roll the backrest cover down and attach the hook-and-loop strips.

6.

Route the wire harnesses through the holes in the backrest cover and engage the lower J-clips.

7.

Install the backrest cover hook-and-loop strips on each side of the backrest.

8.

Install the seat backrest. Refer to Seat Backrest .