PINPOINT TEST G : The Heated Seat is Inoperative/Does Not Operate Correctly - LH
- G1 CHECK THE REAR HEATED SEAT SWITCH OUTPUT
- Ignition OFF.
- Disconnect: Heated Seat Module C3304A .
- While pressing and releasing the LH rear heated seat switch, measure:
Positive Lead Measurement / Action Negative Lead C3304A-2 Ground
Is the resistance less than 5 ohms when the heated seat switch is pressed and greater than 10, 000 ohms when the heated seat switch is released?
Yes GO to G3. No GO to G2. - G2 CHECK THE HEATED SEAT SWITCH CIRCUIT FOR AN OPEN OR SHORT TO GROUND
- Disconnect: Auxiliary Climate Control Assembly C3198A .
Is the resistance less than 3 ohms between the heated seat module and the auxiliary climate control assembly and greater than 10, 000 ohms between the heated seat module and ground?
Yes INSTALL a new auxiliary climate control assembly. REFER to Auxiliary Climate Control . No REPAIR the circuit. - G3 CHECK FOR VOLTAGE TO THE HEATED SEAT MODULE
- Disconnect: Heated Seat Module C3304B .
- Measure:
Positive Lead Measurement / Action Negative Lead C3304B-1 Ground
Is the voltage greater than 11 volts?
Yes GO to G4. No REPAIR the circuit. - G4 CHECK THE HEATER MATS RESISTANCE AND HEATER CIRCUITS FOR AN OPEN
- Measure:
Positive Lead Measurement / Action Negative Lead C3304B-4 Ground
Is the resistance between 3 and 5 ohms?
Yes GO to G9. No GO to G5. - Measure:
- G5 CHECK THE HEATER MATS GROUND CIRCUIT FOR AN OPEN
- Disconnect: Left Rear Cushion Heater Mat C3167 .
- Measure:
Positive Lead Measurement / Action Negative Lead C3167-1 Ground
Is the resistance less than 3 ohms?
Yes GO to G6. No REPAIR the circuit. - G6 CHECK THE HEATER CIRCUIT FOR AN OPEN OR SHORT TO GROUND
- Disconnect: Left Rear Backrest Heater Mat C3168 .
Is the resistance less than 3 ohms between the heated seat module and backrest heater mat, and greater than 10, 000 ohms between heated seat module and ground?
Yes GO to G7. No REPAIR the circuit. - G7 CHECK BACKREST HEATER MAT FOR AN OPEN
- Measure the component side
resistance:
Positive Lead Measurement / Action Negative Lead C3168, pin 1, component side C3168, pin 4, component side
Is the resistance between 0.7 and 1.5 ohms?
Yes GO to G8. No INSTALL a new backrest heater mat. - Measure the component side
resistance:
- G8 CHECK THE CIRCUIT BETWEEN THE CUSHION AND BACKREST HEATER MATS FOR AN OPEN OR A SHORT TO GROUND
Is the resistance less than 3 ohms between the backrest heater mat and the cushion heater mat, and greater than 10, 000 ohms between backrest heater mat and ground?
Yes INSTALL a new cushion heater mat. No REPAIR the circuit. - G9 CHECK THE TEMPERATURE SENSOR INPUT CIRCUIT FOR A SHORT TO VOLTAGE
- Ignition ON.
- Measure:
Positive Lead Measurement / Action Negative Lead C3304A-3 Ground
Is any voltage present?
Yes REPAIR the circuit. No GO to G10. - G10 CHECK THE TEMPERATURE SENSOR INPUT CIRCUIT FOR A SHORT TO GROUND
- Ignition OFF.
- Measure:
Positive Lead Measurement / Action Negative Lead C3304A-3 Ground
Is the resistance greater than 10, 000 ohms?
Yes GO to G11. No REPAIR the circuit. - G11 CHECK THE TEMPERATURE SENSOR CIRCUITS FOR AN OPEN
Is the resistance between 300 ohms and 300, 000 ohms?
Yes INSTALL a new heated seat module. REFER to Heated Seat Module . No GO to G12. - G12 CHECK THE TEMPERATURE SENSOR FOR AN OPEN
- Disconnect: Left Rear Seat Backrest C3168 .
- Measure the component side
resistance:
Positive Lead Measurement / Action Negative Lead C3168, pin 2, component side C3168, pin 3, component side
Is the resistance between 300 ohms and 300, 000 ohms?
Yes GO to G13. No INSTALL a new rear seat backrest heater mat. - G13 CHECK THE TEMPERATURE SENSOR CIRCUIT FOR AN OPEN
Is the resistance less than 3 ohms?
Yes REPAIR circuit CHS56 (YE/VT) for an open. No REPAIR the circuit.

