Seat Latch - Power: Installation

NOTE: On the first press of the seat control switch after the seat is repaired and a new system component has been installed, the PFSM moves the seat to the home position (seat folded and latched to the floor) before continuing to move to the selected seat position. This allows the PFSM to relearn the position of the affected motors.

1.

Install the power seat latch in the following sequence.
- Tighten to 48 Nm (35 lb-ft).
1. 2.
  
  Connect the 2 electrical connectors.
1. 3.
  
  Install the 2 screws.

2.

Secure the cushion cover retainers.

3.

Install the latch cover, secure the tab and install the screw.

4.

Install the load floor panel and secure the retainers.

5.

Install the 2 load floor panel screws at the back of the cushion.

6.

Attach the wire harness retainers and connect the electrical connectors to the load floor and to the vehicle.

7.

Secure the 2 load floor supports.