PINPOINT TEST Q : All Passenger Windows Are Inoperative

Q1 CHECK REAR PASSENGER WINDOW OPERATION FROM THE LH FRONT WINDOW CONTROL SWITCH

Ignition ON.

NOTE: Make sure the LH window control switch lockout switch is in the UNLOCK position.

Attempt to operate the rear passenger windows from the LH front window control switch.

Do the rear passenger windows operate from the LH front window control switch?

Yes	GO to Q2.
No	For Base, REPAIR circuit CBP01 (BU) for an open. For XLT or Limited, GO to Q3.

Q2 CHECK THE LH FRONT WINDOW CONTROL SWITCH LOCK-OUT CIRCUIT FOR AN OPEN

Ignition OFF.

Disconnect: LH Front Window Control Switch C504 (XLT, Limited) or C535A (Base).

Disconnect: LH Rear Window Control Switch C701 .

Measure:

Positive Lead	Measurement / Action	Negative Lead
C701-5	Courtesy of FORD MOTOR COMPANY	(XLT, Limited) or (Base) C535A-3

Is the resistance less than 3 ohms?

Yes	INSTALL a new LH front window control switch. Refer to Window Control Switch .
No	For police vehicles, VERIFY in-line connector C3206 is connected. If connected, REPAIR the circuit. If not connected, the system is operating correctly. The in-line connector, when removed, disables the rear window operation except from the master window control switch.For non-police vehicles, REPAIR the circuit.

Q3 CHECK THE REAR WINDOW CONTROL SWITCH POWER FEED FOR AN OPEN OR SHORT TO GROUND

Ignition OFF.

Disconnect: BCM C2280D .

Disconnect: LH Rear Window Control Switch C701 .

Measure:

Positive Lead	Measurement / Action	Negative Lead
C701-1	Courtesy of FORD MOTOR COMPANY	Ground

Measure:

Positive Lead	Measurement / Action	Negative Lead
C701-1	Courtesy of FORD MOTOR COMPANY	C2280D-27

Is the resistance greater than 10, 000 ohms between the window control switch and ground; and less than 3 ohms between the window control switch and BCM ?

Yes	INSTALL a new BCM circuit breaker 48 (30A).
No	REPAIR the circuit.