LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2015 >> Explorer Limited, 3.5L Eng VIN 8, AWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Door Handles, Door Locks, Door Latches And Entry Systems - Without Intelligent Access (IA) >> Removal And Installation >> Rear Door Latch >> Removal

Rear Door Latch: Removal

  1. 1.

    Remove the rear door trim panel. REFER to Interior Trim and Ornamentation .

  1. 2.

    Remove the exterior door handle. Refer to Exterior Door Handle .

  1. 3.

    Position the weather shield aside.

  1. 4.

    Disconnect the rear door latch actuator electrical connector.

  1. 5.

    Remove the rear door lock push rod from the door lock rod.

  1. 6.

    Push the door lock rod and grommet through the door panel.

  1. 7.

    Push the interior door handle cable and grommet through the door panel, and pull them back out through the door panel access hole.

  1. 8.

    • To install, tighten to 8 Nm (71 lb-in).
GFD37618Courtesy of FORD MOTOR COMPANY

  1. 9.

    Loosen the exterior rear door handle reinforcement carrier screw.
    • To install, tighten to 7 Nm (62 lb-in).
GFD37680Courtesy of FORD MOTOR COMPANY

  1. 10.

    Slide the exterior rear door handle reinforcement to the front of the vehicle and push it inside the door.

  1. 11.

    Remove the 3 rear door latch screws.
    • To install, tighten to 12 Nm (106 lb-in).

  1. 12.

    Remove the complete latch, carrier, and handle reinforcement assembly from the door.

  1. 13.

    Open the clip and disconnect the exterior front door handle actuating rod.

  1. 14.

    Remove the door latch from the exterior rear door handle reinforcement carrier.