Seat Track: Removal
NOTE:
For parts identification and location, refer to Seat - Exploded View, Front .
- 1.
Remove the safety belt buckle and pretensioner. REFER to Safety Belt System .
- 2.
Remove the seat backrest. Refer to Seat Backrest .
- 3.
Remove the seat cushion cover. Refer to Seat Cushion Cover .
- 4.
If equipped, remove the seat cushion TED. Refer to Seat Cushion Thermo-Electric Device (TED) .
- 5.
If equipped, remove the DSM. Refer to Driver Seat Module (DSM) .
- 6.
If equipped, remove the DCSM. Refer to Dual Climate Controlled Seat Module (DCSM) .
- 7.
Remove the seat position sensor in the following sequence:- Disconnect the seat position sensor electrical connector.
- Pull the locking tab downward to disengage.
- Slide the seat position sensor backward to disengage and remove it from the seat track bracket.
- 8.
If equipped, disconnect the cushion heater mat electrical connector, located at the front of the seat track, and separate the wire harness retainer.
NOTE:
Note the wire harness routing for installation.
- 10.
For a passenger seat, separate the Occupant Classification System Module (OCSM) from the bracket in the following sequence:- Slide an appropriate tool in the slot between the OCSM and bracket.
- Carefully lift the tool end to bend the bracket tab and slide the OCSM off the bracket.
NOTE:
Using excessive force when bending the bracket can damage the Occupant Classification System Module (OCSM) housing.
- 11.
For a passenger seat, detach the Occupant Classification System (OCS) bladder pin-type retainers.
- 12.
For a passenger seat, route the Occupant Classification System Module (OCSM) and hose through the cushion support wires.
NOTE:
Power seat track on top, manual seat track on bottom.
