PINPOINT TEST H : The Heated Seat is Inoperative/Does Not Operate Correctly - RH
- H1 CHECK THE REAR HEATED SEAT SWITCH OUTPUT
- Ignition OFF.
- Disconnect: Heated Seat Module C3304A .
- While pressing and releasing the RH rear heated seat switch, measure:
Positive Lead Measurement / Action Negative Lead C3304A-8 Ground
Is the resistance less than 5 ohms when the heated seat switch is pressed and greater than 10, 000 ohms when the heated seat switch is released?
Yes GO to H3. No GO to H2. - H2 CHECK THE HEATED SEAT SWITCH CIRCUIT FOR AN OPEN OR SHORT TO GROUND
- Disconnect: Auxiliary Climate Control Assembly C3198A .
Is the resistance less than 3 ohms between the heated seat module and the auxiliary climate control assembly and greater than 10, 000 ohms between the heated seat module and ground?
Yes INSTALL a new auxiliary climate control assembly. REFER to Auxiliary Climate Control . No REPAIR the circuit. - H3 CHECK FOR VOLTAGE TO THE HEATED SEAT MODULE
- Disconnect: Heated Seat Module C3304B .
- Measure:
Positive Lead Measurement / Action Negative Lead C3304B-3 Ground
Is the voltage greater than 11 volts?
Yes GO to H4. No REPAIR the circuit. - H4 CHECK THE HEATER MATS RESISTANCE AND HEATER CIRCUITS FOR AN OPEN
- Measure:
Positive Lead Measurement / Action Negative Lead C3304B-6 Ground
Is the resistance between 3 and 5 ohms?
Yes GO to H9. No GO to H5. - Measure:
- H5 CHECK THE HEATER MATS GROUND CIRCUIT FOR AN OPEN
- Disconnect: Right Rear Cushion Heater Mat C3169 .
- Measure:
Positive Lead Measurement / Action Negative Lead C3169-1 Ground
Is the resistance less than 3 ohms?
Yes GO to H6. No REPAIR the circuit. - H6 CHECK THE HEATER CIRCUIT FOR AN OPEN OR SHORT TO GROUND
- Disconnect: Right Rear Backrest Heater Mat C3170 .
Is the resistance less than 3 ohms between the heated seat module and backrest heater mat, and greater than 10, 000 ohms between the heated seat module and ground?
Yes GO to H7. No REPAIR the circuit. - H7 CHECK BACKREST HEATER MAT FOR AN OPEN
- Measure the component side
resistance:
Positive Lead Measurement / Action Negative Lead C3170, pin 1, component side C3170, pin 4, component side
Is the resistance between 0.7 and 1.5 ohms?
Yes GO to H8. No INSTALL a new backrest heater mat. - Measure the component side
resistance:
- H8 CHECK THE CIRCUIT BETWEEN THE CUSHION AND BACKREST HEATER MATS FOR AN OPEN OR A SHORT TO GROUND
Is the resistance less than 3 ohms between the backrest heater mat and cushion heater mat, and greater than 10, 000 ohms between the backrest heater mat and ground?
Yes INSTALL a new cushion heater mat. No REPAIR the circuit. - H9 CHECK THE TEMPERATURE SENSOR INPUT CIRCUIT FOR A SHORT TO VOLTAGE
- Ignition ON.
- Measure:
Positive Lead Measurement / Action Negative Lead C3304A-9 Ground
Is any voltage present?
Yes REPAIR the circuit. No GO to H10. - H10 CHECK THE TEMPERATURE SENSOR INPUT CIRCUIT FOR A SHORT TO GROUND
- Ignition OFF.
- Measure:
Positive Lead Measurement / Action Negative Lead C3304A-9 Ground
Is the resistance greater than 10, 000 ohms?
Yes GO to H11. No REPAIR the circuit. - H11 CHECK THE TEMPERATURE SENSOR CIRCUITS FOR AN OPEN
Is the resistance between 300 ohms and 300, 000 ohms?
Yes INSTALL a new heated seat module. REFER to Heated Seat Module . No GO to H12. - H12 CHECK THE TEMPERATURE SENSOR FOR AN OPEN
- Disconnect: Right Rear Seat Backrest C3170 .
- Measure the component side
resistance:
Positive Lead Measurement / Action Negative Lead C3170, pin 2, component side C3170, pin 3, component side
Is the resistance between 300 ohms and 300, 000 ohms?
Yes GO to H13. No INSTALL a new rear seat backrest heater mat. - H13 CHECK THE TEMPERATURE SENSOR CIRCUIT FOR AN OPEN
Is the resistance less than 3 ohms?
Yes REPAIR circuit CHS56 (YE/VT) for an open. No REPAIR the circuit.

