LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2021 >> Voyager LX, Gas >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Accessories Control Systems >> Power Liftgate (Service Information) >> Sensor, Pinch >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING:

Use extreme caution when testing pinch sensor operation.

  1. Route the pinch sensor wire harness through the hole in the liftgate. Push the wire harness grommet into place until fully seated.
  2. Position the pinch sensor onto the liftgate and install the retainers.
  3. Connect the pinch sensor wire harness connector.
  4. Install the liftgate trim panels. Refer to PANEL, TRIM, REMOVAL AND INSTALLATION .
  5. Connect the battery negative cable.
  6. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes related to the pinch sensor.
  7. Verify power liftgate system and pinch sensor operation. Cycle the power liftgate through one complete open and close cycle, during the final close cycle press the pinch sensor to verify the power liftgate detects an obstruction and returns to the full open position.
scientia non olet · About LEMON Manuals