Remove & Install or Remove & Replace
WARNING: This page is about the Voyager L, Gas, which is a different variant/trim than selected.
NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Both Sides,w/Intermediate Shaft | 1.8 | B | ||
| Both Sides,w/o Intermediate Shaft | 1.6 | B | ||
| Left | 0.9 | B | ||
| Right,w/Intermediate Shaft | 1.1 | B | ||
| Right,w/o Intermediate Shaft | 0.9 | B | ||
| Additional Procedure: AXLE SHAFT ASSEMBLY: Remove & Install or Remove & Replace: | ||||
| w/Belly Pan Removal | 0.3 | B | ||
| Combination Procedure: AXLE SHAFT: Replace: NOTE: For Independent Suspension Type Axles, this operation consists of dissassembly and reassembly of the Axle Shaft Assembly and replacement of the Axle Shaft. | ||||
| Serviced in Axle Shaft Assembly. | B | |||
| Combination Procedure: AXLE SHAFT BOOT: Remove & Replace: | ||||
| Inner &/or Outer,Each Side | 1.0 | B | ||
| Combination Procedure: AXLE SHAFT SEAL: Remove & Replace: | ||||
| Each | 0.2 | B | ||
| Combination Procedure: CONSTANT VELOCITY JOINT: Remove & Replace: | ||||
| Each | 0.5 | B | ||