LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2021 >> Voyager LX, Gas >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Electronic Control Modules (Service Information) >> Module, Keyless Ignition Node (Kin) >> Removal And Installation >> Removal

Removal And Installation: Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL AND INSTALLATION .
    GC0177301Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the wiring harness connector (2) from the back of the Keyless Ignition Node (KIN) module (1).
  4. Remove the center instrument trim panel. Refer to PANEL, INSTRUMENT PANEL TRIM, CENTER, REMOVAL AND INSTALLATION .
    GC0177552Courtesy of CHRYSLER GROUP, LLC
  5. To remove the KIN from the trim panel, depress the release tabs (1) and push the KIN outward from the inside of the panel until free.
scientia non olet · About LEMON Manuals